Installation Instructions

Model:
360.210
Collapsible Water Barrier
READ ALL INSTRUCTIONS CAREFULLY AND INSPECT PRODUCT FOR DAMAGE BEFORE STARTING YOUR INSTALLATION.
INCLUDED IN PACKAGE:
One (1) 67” Long Collapsible Water Barrier
Instructions on package
TOOLS AND MATERIALS REQUIRED FOR INSTALLATION:
Utility knife
Tape measure
100% Silicone sealer (white or clear)
Masking tape
Rubbing alcohol
Clean rags
SURFACE PREPARATION:
Clean threshold and wipe with rubbing alcohol.
INSTALLATION
NOTE: The Collapsible Water Barrier (Strip) is 67" long and requires trimming to install.
STEP 1:
Start at one end when preparing the cut to length.
STEP 2:
Be sure to account for the angled side walls of the shower floor.
STEP 3:
Use masking tape to hold down the Strip while measuring and making the cut. DO NOT REMOVE FILM FROM
ADHESIVE TAPE AT THIS TIME!
STEP 4:
Use a pencil to mark the location of the strip on the threshold.
STEP 5:
Remove 6" of the protective film from sealing tape to start the installation.
STEP 6:
Apply sealer/adhesive to the cut end of the Strip.
STEP 7:
Using the pencil mark, align the Strip on the threshold. Press firmly to adhere the Strip. Stretch opposite end to wall and
recheck alignment.
E.L. Mustee & Sons, Inc.
5431 West 164th St.
Brook Park, OH 44142
Phone: [phone]
Fax: [phone]
Email: [e-mail]
Web: www.mustee.com
INSTALLATION INSTRUCTIONS