Installation Instructions

Model:
390
SERIES
CareGiver
®
Straight & Angled Grab Bars
READ ALL INSTRUCTIONS CAREFULLY AND INSPECT PRODUCT FOR DAMAGE BEFORE STARTING YOUR INSTALLATION.
Angled 90° Angled 120° Inside CornerStraight
INCLUDED IN CARTON:
One (1) straight or angled CareGiver
®
grab bar
One (1) set of installation instructions
TOOLS AND MATERIALS REQUIRED FOR INSTALLATION:
Electric drill
1
/
8
" wood or metal drill bit
1
/
4
" masonry drill bit (Only needed if installing on a tiled wall. See instructions, Step 1)
Tape measure
Twist-Lock Concealed Flange
Screwdriver
Level
Eight (8) #12 x 2" pan head self-tapping screws
PREPARATION:
Check local code for proper placement of Grab Bar to meet requirement
such as ADA or ANSI 117.1 Consumer Safety Requirements.
Before installing the Grab Bar you wil have to prepare the area.
Rough-in Installation: Determine where the Grab Bar will be mounted
and install bracing to the rough-in framing to support the Grab Bar through
the shower wall.
Existing Wall Installation: Locate stud behind the existing shower wall to
determine where the Grab Bar can be safely mounted.
Clean that portion of the shower wall where the Grab Bar will be installed.
Please read the instructions before proceeding with the installation.
CareGiver
®
Grab Bars are only as strong as the
strength and rigidity of the material to which
they are mounted. They must be mounted
through shower wall and screwed directly to
wood or metal stud.
E.L. Mustee & Sons, Inc.
5431 West 164th St.
Brook Park, OH 44142
Phone: [phone]
Fax: [phone]
Email: [e-mail]
Web: www.mustee.com
INSTALLATION INSTRUCTIONS
ELM-234 390serCGrabBar SI-221_R6.indd 1 12/15/09 11:51:59 AM