User manual

-12- -13-
3.4 Shutdown
If the equipment is not load, long press the PWR button on the front panel for more
than three seconds, the device will shut down, solid red becomes red flashing power
indicator panel after a successfully shut down.

Shutdown process, the system prompts are off, do not cut off the power。

Equipment running directly through the rear panel power off switch, cut off the
power or unplug the power cord should be avoided.

In some circumstances, the power supply is not normal, will lead to the NVR not to
work properly, serious damage can occur to the NVR. In this environment, it is
recommended to use regulated power supply, or a backup AC source.

If the device is logged into the main interface, you can click the top right
Button or long press the PWR button on the front panel for more than three seconds
will bring up the shutdown interface, shown in Figure 3-4Interface.
Figure 3-4 Shutdown interface
3.5 Displayer resolution adjustment
NVR support resolutions with VGA 1024*768, VGA 1280*1024, VGA1600*1200,
HDMI720P, HDMI1080P, you can select the proper resolution according your
displayer.
For display using VGA set to 1024*768 or VGA 1280*1024. When using HDMI input we
advise to use HDMI 1080P.
Adjustment Steps:
Step 1 Click Change on login interface and find the adjustment interface shown in Figure 3-5.
Figure 3-5 Adjust displayer
Step 2 Choose the type of resolution in the resolution of the drop-down box.
Device will automatically switch to the selected resolution and show the dialog for Yes
or Cancel.

If no operate in 10 seconds, displayer will back to previous resolution.

If select Yes then will switch to the selected resolution.

If select cancel display will not save the configuration and back to previous
resolution.
Step 3 Adjust display.
If displayer couldn’t show the full screen (at the corners can’t see
) then we need to
adjust the displayer (we advise to auto adjust first )
1. Click Adjustment button at lower right corner.
2. In the step of the drop-down box to choose the adjustment step.
Step: The moving distance when adjust screen each times , the greater number the
more moving distance, you can select the larger step sizes to adjust sketchy, and
then select the smaller step tuning.
3. Use UP, DOWN, LEFTRIGHT button to adjust the screen.
Step 4 Click the configuration interface
to close.
Exist displayer interface
eLineTechnology.com