Owner manual
2 - Installation
1212m Owners - Install the 0202 Daughter Card
16 Creative Professional
1212
m
Owners - Install the 0202 Daughter Card
PCI Slots
PCIe x1
PCIe x1
Figure 3
0202
Daughter
Card
1. Unwrap the 0202 Daughter Card and get
ready to install it.
2. Connect the provided ribbon cable
between the E-MU 1010 PCIe card and the
0202 Daughter card as shown in figure 3.
The cable is keyed so it cannot be incor-
rectly inserted. Seat the connectors firmly
in the sockets and arrange the cable neatly.
3. Align the 0202 Daughter Card with the
back panel slot and press gently but firmly
down into the slot as shown in figure 2 on
the preceding page.
4. Do not force the 0202 Daughter Card into
the slot. The bottom of the card does not fit
into the PCIe slot. The rear panel mounting
holds it in place.
5. Secure the card into the slot using one of
the screws you placed aside earlier.
6. After all components have been installed
and securely fastened, close the computer
case.
CAUTION: Do not
connect the supplied
CAT5 cable to the
Ethernet or network
connector on your
computer. Doing so may
result in permanent
damage to either your
computer, the E-MU 1010
or both.
7.
Connect the supplied network-type cable from the 10 BaseT jack on the E-MU
1010 PCIe card labeled “EDI” to the matching connector labeled “EDI” on the
MicroDock. The cable supplied with the MicroDock is specially shielded to prevent
unwanted RF emissions.
8. Plug the power cord back into the wall outlet and turn on your computer.
Connecting the MicroDock
EDI
48
VDC
+
-
The Headphone
Volume Control is
the Power Switch.
+48V DC Adapter
1010 PCIe Card
1. Connect the supplied EDI cable between the 1010 PCIe Card and the MicroDock.
2. Connect the supplied +48 volt DC adapter to the +48VDC jack on the rear of the
MicroDock. See the diagram below.
3. Connect your audio inputs and outputs to the MicroDock as shown on page 25.
4. Turn the MicroDock on by turning the Headphone Volume control.
Note: The 1616
m
MicroDocks cannot be
used with older 1010 PCI
cards identified by the
1394 FireWire port.