User's Manual
29
Network configurations
Using HUB (supports switching for more than 100M)
Select "Internet Protocol (TCP/IP)" and click <Properties>.
(For Windows 2000,select <Registration Information>.)
4.
When configuration is complete,click <Save>to exit the settings screen and click <Connect>.
11.
You can see that PC and NEOTUS are now connected.You can start using the NEOTUS.
10.
Select the LAN card ,right click with the mouse and select
"Properties". (For Windows 2000,select the LAN card ,right click
with the mouse and select "Properties".
3.
Double click on the "Nework Connection" icon.
2.
Click <Start>from Windows and select "Control Panel".
Click <Start>from Windows and select "Control Panel".
To connect to the hub,both the host computer and NEOTUS must use fixed IP.Select "Network Connections" ("Network
and dial-up connections") in the "Control Panel" and select the LAN card. Right click with the mouse and select
"Properties" ("Registration Information ") and set to fixed IP for both the computer and NEOTUS. Set the fixed IP as fol-
l o w s
1.
28
Network configurations
When network configu
r
ation is complete,click <Save>to exit
the settings screen and click <Connect>.
9.
'Click the 'TS Options' tab and configure as follows.
(Enter the host computer's IP address set in step 5 in the
Terminal Server Network address field.)
8.
Select the "Network" tab,select "Use Static IP address" and
enter the IP address and gateway.
7.
To configure NEOTUS' settings,turn on the NEOTUS monitor and
press the input signal button to conver to the network and click the
"Setup" menu fro
m
the start page.
6.
Configure the settings as shown in the screen shot to the right and
click <OK>.
(Select "Next IP address" and enter the IP address,subnet mask
and default gateway.Then select "Use the following DNS server
address" and enter the default DNS server address.)
5.
You can see that PC and NEOTUS are now connected.
You can start using the NEOTUS.
10.