N20 encoder

down to the two terminals, the motor leads are connected to the M1 and M2 pads along the edge of the board; the remaining four
pads are used to power the sensors and access the two quadrature outputs:
The sensors are powered through the VCC and GND pins. VCC can be 2.7 V to 18 V, and the quadrature outputs A and B are
digital signals that are either driven low (0 V) by the sensors or pulled to VCC through 10 kΩ pull-up resistors, depending on the
applied magnetic field. The sensors’ comparators have built-in hysteresis, which prevents spurious signals in cases where the
motor stops near a transition point.
The board’s six pads have a 2 mm pitch, soldered with a top entry, 6-Pin Female JST SH-Style Cable, 12cm
Wires Length : 150mm