Installation manual

53
PROGRAMMING
E-TECH ET8 (V4) CONTROL PANEL – INSTALLER MANUAL
CLEAR MEMORY
Enter P96E when in Installer Program mode to clear all events in the Alarm memory display.
PROGRAMMING SEQUENCE:
P96E Clears Alarm Memory display
P96E
PROGRAM MODE LEVEL:
Installer, Remote by PC
FACTORY DEFAULT:
[not applicable]
OPTION No DESCRIPTION
DEFAULT NOTE
P96E
P95E
P97E
P98E
P99E
Clear Memory
Clear Radio Devices
Restore Factory Defaults
Clear User Codes
Program the Installer Code
not applicable
not applicable
not applicable
not applicable
000000
CLEAR PANEL OPTIONS
This option restores ‘panel’ program options to their factory default values.
Defaults the options P00E, P26E to P93E, P99E.
(This includes all options except User Codes, Radio Codes & Radio Devices).
PROGRAMMING SEQUENCE:
P97E Restores Factory Defaults
P97E
PROGRAM MODE LEVEL:
Installer, Remote by PC
FACTORY DEFAULT:
[not applicable]
NOTES:
CLEAR USER CODES
This option clears all User codes and Radio Codes (Radio Keys) and restores factory
default codes.
P09E–P10E are defaulted (Radio Codes assignment)
P11E – P25E are defaulted (User Codes 1–15)
PROGRAMMING SEQUENCE:
P98E Clears User Codes
P98E
PROGRAM MODE LEVEL:
Installer, Remote by PC
FACTORY DEFAULT:
User Code 1: 123
All other codes: [blank]
NOTES:
• This option DOES NOT clear the Installer Code.
CLEAR RADIO DEVICES
This option clears all Radio Device Codes. (Except Radio Keys assigned to Radio Codes).
Options P01E – P08E are defaulted (eg, Radio PIRs assigned to zones 1–8)
PROGRAMMING SEQUENCE:
P95E Clears Radio Device Codes
P95E
PROGRAM MODE LEVEL:
Installer, Remote by PC
FACTORY DEFAULT:
[not applicable]
These options allow selective
restoring of various factory defaults.
For example, you can default (clear)
all the User Codes, without affecting
any other programmed options.
PROGRAM THE INSTALLER CODE
Programs the installer code. This code can be 3 to 6 digits long. Factory default installer
code is 000000.
PROGRAMMING SEQUENCE:
P99E [Enter new code]E [Enter new code again]E
(Unlike User Codes, the installer code is not displayed when programming)
P99E
PROGRAM MODE LEVEL:
Installer, Remote by PC
FACTORY DEFAULT:
000000
NOTES: