Specifications

8
8-28
1. Turn the key to “OFF” and turn off all electrical
circuits.
NOTICE
To prevent accidental short-circuiting, turn off
the main switch when checking or replacing a
fuse.
new fuse of the specified amperage.
Specified fuse:
10.0 A
The fuse holder is located under the seat.
(See page 4-11.)
If the fuse is blown, replace it as follows.
1. Turn the key to “OFF” and turn off all electrical
circuits.
1. Fuse
2. Spare fuse
NOTICE
Always keep the battery charged. Storing a
discharged battery can cause permanent
battery damage.
To charge a VRLA (Valve Regulated Lead Acid)
battery, a special (constant-voltage) battery
charger is required. Using a conventional
battery charger will damage the battery. If you
do not have access to a constant-voltage
battery charger, have an E-TON dealer charge
your battery.
Replacing the fuse
2
1
3. Turn the key to “ON” and turn on the electrical
circuits to check if the devices operate.
4. If the fuse immediately blows again, have an
E-TON dealer check the electrical system.
2. Remove the blown fuse, and then install a