User's Manual

http://www.sapido.com.tw/ User Manual v1.0.0

A: Force your NIC to 10Mbps or half duplex mode, and turn off the "Auto-negotiate"

feature of your NIC as a temporary measure. (Please look at the Network Control

Panel, in your Ethernet Adapter's Advanced Properties tab.)

4. Q: Why can't I connect to the Web Configuration?

A: you can remove the proxy server settings in your web browser.

9.5 BR485D Setup

1. Q: Why does BR485D’s setup page shut down unexpectedly?

A: If one of the pages appears incompletely in BR485D ’s setup pages, please click on

Logout item on the Main Menu before shutting it down. Don’t keep it working. Then,

close Internet browser and open it again for going back to the previous page.

2. Q: I don’t know how to configure DHCP.

A: DHCP is commonly used in the large local network. It allows you to manage and

distribute IP addresses from 2 to 254 throughout your local network via BR485D .

Without DHCP, you would have to configure each computer separately. It’s very

troublesome. Please Open Internet browser > Input 192.168.1.1 in the website

blank field > Select DHCP Server under the IP Config Menu. For more information,

please refer to 3.3.2 (Router Mode) or 4.3.1 (AP Mode).

3. Q: How do I upgrade the firmware of BR485D ?

A: Periodically, a new Flash Code is available for BR485D on your product supplier’s

website. Ideally, you should update BR485D ’s Flash Code using Firmware Upgrade

on the System Management menu of BR485D Settings.

4. Q: Why is that I can ping to outside hosts, but cannot access Internet websites?

A: Check the DNS server settings on your PC. You should get the DNS servers settings

from your ISP. If your PC is running a DHCP client, remove any DNS IP address

setting. As the router assign the DNS settings to the DHCP-client-enabled PC.

5. Q: BR485D couldn’t save the setting after click on Apply button?

A: BR485D will start to run after the setting finished applying, but the setting isn’t written

into memory. Here we suggest if you want to make sure the setting would be written

into memory, please reboot the device via Reboot under System Management

directory.