Owner`s manual

25
OPERATING PROCEDURES
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
To prevent severe injury or death to operator, occupants or bystanders, select the object to which
the cable is attached with the following considerations:
Make sure the object cannot be pulled over or otherwise damaged.
The object the winch cable is attached to could fall on the vehicle and it’s occupants.
If attaching the winch to a dead tree, a section could fall.
When pulling vehicle with winch, pull straight only. Do not permit the cable to contact the side of
the drum.
Do not pull vehicle at an angle. If the vehicle is pulled at an angle, it could turn over causing
severe injury or death to anyone in the area. The winch cable could also become overstressed
and break causing severe injury or death to anyone struck by the cable.
The rear drive axle is equipped with a manually operated locking differential. With the differential unlocked, if one drive
wheel looses traction, all available power is transferred to that wheel until it regains traction. In normal driving this is not
a problem. However, if the vehicle becomes ‘hung up’ on an object, the vehicle will stop. With the differential locked,
power is distributed to both drive wheels at all times. If both drive wheels lose traction as a result of the vehicle becom-
ing ‘hung up’ on an object, the vehicle will stop. If the vehicle cannot be pushed off the obstruction, it will have to be
pulled off using the winch.
To prevent severe injury or death, read and understand the following before attempting to use
the winch:
The winch is not intended to be used in any hoisting operation.
The rolling load capacity of the winch decreases with the steepness of the slope.
The winch is designed for intermittent duty only.
The electric motor should not be allowed to become exces-
sively hot. If the motor becomes uncomfortably hot to the
touch, stop winching and allow the motor to cool.
Always wear thick leather gloves when handling the wire
cable.
Replace frayed wire cable with a direct factory replacement
only.
Never operate the winch with less than five (5) full turns of
cable around the drum.
If the winch motor stalls from overloading, do not continue to activate the winch remote control. The wire cable may
become overstressed.
Do not attempt to pull loads exceeding the manufacturers maximum load rating.
Have all persons and pets leave the area while operating winch. Never allow anyone to remain in the vehicle.