User's Manual

©e2v technologies (uk) limited 2010 107553 09 Aug 2010 DAS762156AA (UK) Version 11, page 14
On the General tab click on “Use
the following IP Address”.
To ensure that a simple system
will avoid address clashes,
generate the computer address
using the method below.
Use the transmitter serial number
as the last two numbers in the
address.
e.g. for transmitter serial number
20.017, use 10.133.20.17 as the
computer address.
Enter the IP address selected for
the computer in the IP address
boxes, 10.133.20.17 in this
example.
Click in the Subnet mask box and
enter 255.255.0.0.
Enter 1.1.1.1 as the Default
gateway and enter 2.2.2.2 as the
preferred DNS server. These are
dummy values for this simple
connection.
The window should now be
populated as shown opposite.
Then click OK, followed by OK
again.
See FAQ 23 for more detail on
the IP address structure.
Secure the wireless network adaptor in a suitable position for day-to-day use. If it is to be used as
a walk-about hand-held, this will generally be to the computer, while for a fixed installation the
location should be considered carefully to obtain the best reception. For example, in a vehicle, it
would be better on the windscreen or dashboard away from the metal bodywork. If required, USB
extension cables can be obtained from many retail outlets.
This completes the Receiver Kit installation.
A suitable player should be installed at this point if it is not already on the chosen PC/laptop. The
Ateme Player supplied on the CD is recommended and the configuration of this player is covered
in section 8.
INSTRUCTIONS FOR USE
Day-to-day operation is now similar to the receiver station described in section 2.