User's Manual

©e2v technologies (uk) limited 2010 107553 09 Aug 2010 DAS762156AA (UK) Version 11, page 20
SECTION 6 – Analogue Output Battery Pack P7030AVBP
This accessory allows a suitable Argus
®
4 camera to provide an analogue video output signal over
a BNC lead to a suitable display device. This is incorporated in a battery pack that provides power
for the camera. Connection to the camera is by replacing the standard battery with the unit
supplied. There are no user serviceable parts inside.
Analogue video will only be available when coupled to a suitably equipped camera, it is not
present as standard on all cameras.
Models P7030, P7030-LITE, P7009, P7130, P7225/D and P7250/D do not have analogue video
output capability.
Model P7030-LITE does not have any video output facility.
If in doubt please contact your distributor or e2v for advice on use with the cameras that you own.
INSTRUCTIONS FOR USE
The Analogue Output Battery Pack is similar to a standard battery, and should be charged with the
standard camera charger accessories; the mains charger supplied with the camera
(P7030BC+CS) or the vehicle charger (P7030TBC). The battery bar display gives the same
camera display of the battery state as a standard battery, although run time is slightly reduced
when sending video.
When the battery reaches low, as shown below, the video output is automatically turned off to
ensure that final runtime beyond the low battery warning is maintained.
To maintain the accuracy of the battery charge indicator, e2v recommends that batteries be
occasionally fully discharged in a camera before charging.