User's Manual

©e2v technologies (uk) limited 2010 107553 09 Aug 2010 DAS762156AA (UK) Version 11, page 28
Check that the correct frequency is now
shown
1. Click the RF output button to switch
on the radio.
Note the Video lock is green; this
means that the camera analogue video
is being detected by the transmitter.
If this is red, check that the camera has
analogue video output.
3. It is possible to save the
configuration to make future set-up
easier. This is especially the case if
other adjustments have to be made, for
instance to suit a command vehicle set-
up.
If making advanced adjustments, note
that these two settings are not
automatically detected at the receiver. If
changed, these must also be manually
input on the receiver.
The receiver also requires to be set to the transmitter frequency using the configuration software
provided on the CD. Other factory parameters for the receiver should be suitable, but if
transmission parameters are adjusted in the transmitter, the receiver will need to be set to match.
The receiver unit should be charged
before use.
Switch the receiver on.
Connect the serial lead supplied
from the setup connector to the PC
Run the RX setup programme
copied from the CD