User's Manual

©e2v technologies (uk) limited 2010 107553 09 Aug 2010 DAS762156AA (UK) Version 11, page 29
Select the COM port where the
transmitter is connected and click on
Connect.
The word “Connected” should now
turn green.
Enter the frequency of the
transmitter.
Click ‘Apply’.
The screenshot shows a typical
display when a camera is
transmitting nearby. The signal
strength and quality from each
antenna are shown.
The green indicators show that video
is being received and decoded
correctly.
It is also possible to set up more
than one receive frequency if the
location permits more than one
transmit frequency this could allow
two cameras at once. This is set up
in the separate config tabs.
The configuration can be saved to a
file for easy application to further
receiver units.