User's Manual

©e2v technologies (uk) limited 2010 107553 09 Aug 2010 DAS762156AA (UK) Version 11, page 31
INSTRUCTIONS FOR USE
Camera / Transmitter
The transmitter battery pack contains a standard battery and may be charged with the standard
camera charger accessories, the mains charger supplied with the camera (P7030BC+CS) and the
vehicle charger (P7030TBC). It contains circuitry to give the same camera display of the battery
state as a standard battery, although run time is reduced when transmitting, giving a typical 2
hours in ambient temperatures.
When the battery reaches low, as shown below, the transmitter is automatically turned off to
ensure that final runtime beyond the low battery warning is maintained.
To maintain the accuracy of the battery charge indicator, e2v recommends that batteries be
occasionally fully discharged in a camera before charging.
Note: A LRT transmitter battery cannot be charged attached to the camera in the vehicle storage
mount.
It should also be noted that the battery charger might indicate an error due to high battery
temperature following extended use with the transmitter running. Allow the battery to cool before
charging.
Fit the transmitter unit to the
camera as shown below and click
into place.
Switch on the camera with the red
button as normal and a picture will
be seen on the display.
To commence transmitting video, a
long push on the right-hand button
is required.