User's Manual

To install the software, click ’Install Software’ on the main page. This will open
the software page; click ’install software’. A box will appear, asking to copy or to
run the software from its current location. Click ‘run from current location’, then
click ‘OK’. Another box will appear; click ‘Yes’ to install the software. A box will
now appear to update the systems files. When the box disappears, another will
pop up; click ‘OK’ to the installation. Immediately after, there will be a prompt to
restart the system before starting a full installation. Click ‘Yes’ to restart system.
Once the restart has been completed, inst all the software again.
After clicking ‘install software’ for the second time, click ‘OK’ to the installation.
If the insta llation is an older version than the current one on the laptop/PC, there
may be a prompt to keep any .OCK or .DLL files; click ‘Yes’. Click ‘OK’ to the
successful completion to the installati on.
The software should now be correctly installed. To run the Argus
1
3 software,
click on ‘Start’, find the Argus
1
3 software title under Programs, then click the
Argus
1
3 customer software.
The software can be installed by running D:\setup.exe (replace ’D’ with the drive
letter for the CD-ROM drive if necessary). Follow the on-screen commands and
the above procedure.
. Using the Software
Power up the camera and wait
until a thermal image has
appeared on the camera screen.
Connect the data cable between
the camera and laptop/PC. Start
the customer sofware and wait
until the test software front screen
opens. Click connect to camera.
If the connection to the camera
has been successful, connect to
camera will disappear and three
options will be available:
Set Time and Date.
Stored Images.
Advanced Software.
19