SDS

E6000 MV CLEAR AUTO/INDUSTRIAL
Section 8. Exposure controls/personal protection
Hand protection
Eye/face protection
:
:
Environmental exposure
controls
:
Emissions from ventilation or work process equipment should be checked to ensure
they comply with the requirements of environmental protection legislation. In some
cases, fume scrubbers, filters or engineering modifications to the process equipment
will be necessary to reduce emissions to acceptable levels.
Appropriate engineering
controls
:
If user operations generate dust, fumes, gas, vapor or mist, use process enclosures,
local exhaust ventilation or other engineering controls to keep worker exposure to
airborne contaminants below any recommended or statutory limits.
Wash hands, forearms and face thoroughly after handling chemical products, before
eating, smoking and using the lavatory and at the end of the working period.
Appropriate techniques should be used to remove potentially contaminated clothing.
Wash contaminated clothing before reusing. Ensure that eyewash stations and safety
showers are close to the workstation location.
Hygiene measures
:
Individual protection measures
Skin protection
Safety eyewear complying with an approved standard should be used when a risk
assessment indicates this is necessary to avoid exposure to liquid splashes, mists,
gases or dusts. If contact is possible, the following protection should be worn, unless
the assessment indicates a higher degree of protection: chemical splash goggles.
Chemical-resistant, impervious gloves complying with an approved standard should be
worn at all times when handling chemical products if a risk assessment indicates this is
necessary. Considering the parameters specified by the glove manufacturer, check
during use that the gloves are still retaining their protective properties. It should be
noted that the time to breakthrough for any glove material may be different for different
glove manufacturers. In the case of mixtures, consisting of several substances, the
protection time of the gloves cannot be accurately estimated.
tetrachloroethylene
ACGIH TLV (United States, 3/2018). Notes:
Substance identified by other sources as a
suspected or confirmed human carcinogen.
Substances for which there is a Biological
Exposure Index or Indices Substances for
which the TLV is higher than the OSHA
Permissible Exposure Limit (PEL) and/or
the NIOSH Recommended Exposure Limit
(REL). See CFR 58(124) :36338-33351,
June 30, 1993, for revised OSHA PEL.
Refers to Appendix A -- Carcinogens.
STEL: 685 mg/m³ 15 minutes.
STEL: 100 ppm 15 minutes.
TWA: 170 mg/m³ 8 hours.
TWA: 25 ppm 8 hours.
OSHA PEL 1989 (United States, 3/1989).
Notes: See Table Z-2.
TWA: 170 mg/m³ 8 hours.
TWA: 25 ppm 8 hours.
OSHA PEL Z2 (United States, 2/2013).
AMP: 300 ppm 5 minutes.
CEIL: 200 ppm
TWA: 100 ppm 8 hours.
Benzene, ethenyl-, polymer with 1,3-butadiene
None.
Ingredient name
Exposure limits
Date of issue/Date of revision
:
1/18/2019
Version
:
1
5/13