User manual

IVC Card Features and Support

Step Action

1. At a system console, press the control <Ctrl> and z keys at the same time

(<Ctrl-Z>). At the prompt (

ENTER COMMAND ->), enter status to display

general system information.

2. At the prompt, type either fora or forb to force the system to use server A or

server B as the primary server.

By forcing the system to use one server for primary system control, you ensure

that subsequent steps in this procedure do not affect call processing.

3. On the system console for the secondary server, use the <Page Up> or

<Page Down> key to access the console monitor screen. At the prompt,

type XCP to stop call processing on the secondary server.

4. Disconnect the red crossover cable that connects the Inter-processor Link

(IPLK) connectors on both servers (A and B).

5. With an Ethernet cable, connect the IPLK connector on server A to the

Ethernet switching device.

6. With an Ethernet cable, connect the IPLK connector on server B to the

Ethernet switching device.

7. With an Ethernet cable, connect the Ethernet switching device to the Ethernet

card on the PC that runs the Phrase Manager application.

8. With an Ethernet cable, connect the Ethernet switching device to an

AMP-to-RJ45 adapter on the backplane of an Integrated Voice Controller

(IVC) card in the switch.

9. On the system console for the secondary server, type XCM to terminate the

console monitor. At the resulting prompt, press the space bar.

10. Use either the <Page Up> or <Page Down> key to access the TTY5 or TTY7

screen. At the prompt, log in. Then type reboot.

11. After the secondary server reboots, type <Ctrl-Z> from the system console.

At the prompt (

ENTER COMMAND ->), type auto to restore the system's ability

to use either server for primary system control.

Aastra - 2489-005 29