Instructions / Assembly

ManualsBrandsEagle Health Supplies ManualsBathBariatric Sliding Transfer Bench - Regular (Base Length: 39 in. to 40 in.) 500 lb. Weight Capacity, Heavy-Duty

Take the leg frame with the handlebar (Part A), and lay it flat on the ground.

2. Determine which direction you want the seat to face in your bathtub. The leg

frame with the handlebar (Part A) will be the side that goes inside the bathtub.

3. There are two sliding rails (Part C): one rail has 4 brass push buttons (front rail),

and the other rail has 2 brass push buttons (rear rail).

4. If you prefer to sit facing left (if looking at the tub from outside), take the rail

with 4 push buttons (front rail), and insert it into tube X

(or insert it into tube Y if you want to sit facing right).

Make sure the two larger push buttons face down, and the two

smaller push buttons face outwards (the smaller push buttons

are for the sliding rail locking mechanisms). Make sure

the larger, bottom button snaps firmly into the leg

frame.

5. Insert the other sliding rail (rear) into the other side

of the leg frame (Part A), making sure the button snaps

firmly into place.

Take the seat with the attached

sliding rings (Part D), and align

the sliding rings with the rails,

so that the locking side of the seat

(the side with the red tabs)

is on the same rail

as the 4 brass push

buttons (front rail).

Insert both sliding

rails into the sliding

rings under

the seat. Push in

the push buttons to

slide the seat easily

onto the rails.

Take the other leg frame (Part B),

and insert the sliding rails into it.

Make sure the brass buttons snap

firmly into place.

Take the 4 legs (Part E), and insert

them into the leg frames. Set

the bench height by using the same

button-hole location for each leg.

Make sure the buttons snap firmly

into place. For your safety, adjust

the rubber tips on

the legs by

turning them

outward for

maximum

floor

contact.

Sit the bench up on the legs. Take

the backrest (Part F), and insert

the backrest into the two oblong

holes on the top of the seat towards

the rear of the seat.

Push the backrest down

firmly into the seat

until the

backrest

snaps into

place.

Summary of content (2 pages)

PAGE 1
. Take the leg frame with the handlebar (Part A), and lay it flat on the ground. 2. Determine which direction you want the seat to face in your bathtub. The leg frame with the handlebar (Part A) will be the side that goes inside the bathtub. 3. There are two sliding rails (Part C): one rail has 4 brass push buttons (front rail), 4. 5. and the other rail has 2 brass push buttons (rear rail).
PAGE 2
Locking Mechanism Lock the seat into place by making sure the slide ring snaps firmly onto the brass push button at the end of the sliding rail (shown below). Release the locking mechanism by pressing down on the red tab of the locked slide ring. UNLOCKED LOCKED Swivel Seat Press down on the red tab located under the center of the seat’s front edge to turn the swivel seat, and rotate the seat slightly. Once the seat starts to swivel, release the red tab. The swivel seat locks every 90 degrees.