Instructions / Assembly

ManualsBrandsEagle Health Supplies ManualsBathSwivel Sliding Bath Transfer Bench - Regular (Base Length: 39 in. to 40 in.) 400 lb. Weight Capacity, Heavy-Duty

Take the leg frame with the handlebar (Part A), and lay it flat on the ground.

2. Determine which direction you want the seat to face in your bathtub. The leg

frame with the handlebar (Part A) will be the side that goes inside the bathtub.

3. There are two sliding rails (Part C): one rail has 4 brass push buttons (front rail),

and the other rail has 2 brass push buttons (rear rail).

4. If you prefer to sit facing left (if looking at the tub from

outside), take the rail with 4 push buttons (front rail), and

insert it into tube X (or insert it into tube Y if you want to sit

facing right). Make sure the two larger push buttons face

down, and the two smaller push buttons face outwards

(the smaller push buttons are for the sliding rail locking

mechanisms). Make sure the larger, bottom button snaps

firmly into the leg frame.

5. Insert the other sliding rail (rear) into the other side

of the leg frame (Part A), making sure the button snaps

firmly into place.

Take the seat with the attached

sliding rings (Part D), and align

the sliding rings with the rails,

so that the locking side

of the seat (the side

with the red tabs)

is on the same rail

as the 4 brass push

buttons (front rail).

Insert both sliding rails

into the sliding rings

under the seat. Push in

the push buttons to

slide the seat easily

onto the rails.

Take the other leg frame (Part B),

and insert the sliding rails into it.

Make sure

the brass

buttons snap

firmly into

place.

Take the 4 legs (Part E), and insert

them into the leg frames. Set

the bench height by using the same

button-hole location for each leg.

Make sure the buttons snap firmly

into place. For your safety, adjust

the rubber

tips on

the legs by

turning them

outward for

maximum

floor contact.

Sit the bench up on the legs. Take

the backrest (Part F), and press

the two brass push buttons on

the frame of the backrest. Insert

the backrest

into the tubes

underneath

the seat, and

push it in until

the brass push

buttons snap

firmly into

place.

Summary of content (2 pages)

PAGE 1
. Take the leg frame with the handlebar (Part A), and lay it flat on the ground. 2. Determine which direction you want the seat to face in your bathtub. The leg frame with the handlebar (Part A) will be the side that goes inside the bathtub. 3. There are two sliding rails (Part C): one rail has 4 brass push buttons (front rail), 4. 5. and the other rail has 2 brass push buttons (rear rail).
PAGE 2
Safety Belt For added security and stability, adjust the safety belt around the user’s lap. Locking Mechanism Lock the seat into place by making sure the slide ring snaps firmly onto the brass push button at the end of the sliding rail (shown below). Release the locking mechanism by pressing down on the red tab of the locked slide ring. UNLOCKED LOCKED Swivel Seat Press down on the red tab located under the center of the seat’s front edge to turn the swivel seat, and rotate the seat slightly.