Manual

ManualsBrandsEagle Microsystems ManualsSensorsGD-1000

EAGLE MICROSYSTEMS. INC.

Instrumentation for Measurement and Control

1 copyright 2/02

Premier Series Monitor

GD-1000 GAS DETECTOR

INSTALLATION AND OPERATION

MANUAL

EAGLE MICROSYSTEMS, INC.

366 Circle of Progress

Pottstown, PA 19464

PHONE: 610-323-2250 FAX: 610-323-0114

IHPN 630600

SENSOR

Summary of content (6 pages)

PAGE 1
EAGLE MICROSYSTEMS. INC. Instrumentation for Measurement and Control Premier Series Monitor GD-1000 GAS DETECTOR INSTALLATION AND OPERATION MANUAL SENSOR IHPN 630600 EAGLE MICROSYSTEMS, INC.
PAGE 2
EAGLE MICROSYSTEMS. INC. Instrumentation for Measurement and Control Premier Series Monitor TABLE OF CONTENTS: SPECIFICATIONS: QUICK START: OPERATION: ALARM: CALIBRATION: BATTERY BACKUP: WIRING: Page 2 Page 2 Page 3 Page 3/4 Page 4/5 Page 5 Page 6 Installing, wiring and display operation. Main run screen, password entry screen and monitor setup screen. Critical and danger screens. Analog input (CH1), Analog output (IOUT).
PAGE 3
EAGLE MICROSYSTEMS. INC. Instrumentation for Measurement and Control Premier Series Monitor OPERATION: MAIN RUN SCREEN: The value displayed is the type of sensor and its scaled output in ppm. Below the sensor type and value is a fifty segment bar-graph representation of the monitors full scale and the 4mA to 20mA output (PO1). To enter the configuration and calibration screens press SET. The display will prompt you to enter a password. 1 2 3 4 SET Press SET to enter a password screen. SO2 0.
PAGE 4
EAGLE MICROSYSTEMS. INC. Instrumentation for Measurement and Control ALARM SCREEN: Press the pushbutton under CRT or DGR, to configure. Press ESC to return. 1 CRT Critical alarm screen to set value for relay contact. 2 DGR Danger alarm screen to set value for relay contact. 3 4 ESC Go back to the monitor setup screen. SEL SO2 CH1 ALM CRT DGR ESC CRITICAL ALARM SETUP SCREEN: From the critical alarm setup screen you can view the current value.
PAGE 5
EAGLE MICROSYSTEMS. INC. Instrumentation for Measurement and Control CALIBRATE ANALOG INPUT CH1 SCREEN: A device generating a calibrated 4-20mA output is required. The current SET CH1 analog input is displayed in the top right of the screen. Use a calibrated ZRO SPAN analog input or other device to calibrate the zero and full scale value. 1 ZRO Press to enter the value being input as the calibrated zero. 2 SPAN Press to enter the value being input as the calibrated standard.
PAGE 6
EAGLE MICROSYSTEMS. INC.