User`s manual

- 11
60 1.195 6.12 8.16 12.24 24.48 36.72 48.96
50 1.172 6.05 8.07 12.10 24.20 36.31 48.41
40 1.148 5.98 7.97 11.96 23.92 35.87 47.83
30 1.124 5.91 7.88 11.81 23.63 35.44 47.26
20 1.098 5.83 7.77 11.66 23.32 34.97 46.63
10 1.073 5.75 7.67 11.51 23.02 34.52 46.03
7) Battery installation
Tighten the battery cables to battery terminals with torque of 95-105lbs.inch or 10.7-11.9 N.M. Make sure there
is nothing else between the battery cable lug and battery terminal post.
▼
▼
▼
W
W
W
a
a
a
r
r
r
n
n
n
i
i
i
n
n
n
g
g
g
:
:
:
When working with the battery, DO NOT put wrenches or any other metal objects across the battery
terminals, otherwise, an arc can occur, and it may cause explosion of the battery and physical injury.
Battery is installed or replaced only by the qualified electrician.
7.2 Maintenance of the Gear Box:
① The clearance for the clutch should be kept between 2-3mm.
② The friction plate should be changed periodically; the friction value on one side should not exceed 2mm.
③ Adjust the flatness of the platen spring plate (feeling manually): first tighten the screws diagonally, use your
hand to check the flatness of the spring plate. If not flat, tighten the screws for the non-flat part.
④ Change the gear oil inside the gear box periodically (for new vehicle, change the oil after one month or
accumulated running distance exceed 1200kms; change the oil again two months later, then change the oil
every half a year) The oil type is 85W/90GL.
⑤ Clean the gear box before changing the oil.
C
C
C
a
a
a
u
u
u
t
t
t
i
i
i
o
o
o
n
n
n
!
!
!
Never mix different oils.
7.3 Maintenance of the Traction Motor
① This traction motor is designed to use at the sea level not beyond 1200 meters and in a temperature
between -25℃ and 40℃.
② This motor can work properly with a voltage produced by battery in series.
③ Never keep the motor running idly.
④ No explosive gas shall exist in the air.
⑤ Any mud, sand and other clinging objects shall often be cleaned away so as to provide good heat-radiation.
⑥ Check the carbon brush every three months, change the worn carbon brush and weaken carbon brush