Manualshelf

User`s manual

ManualsBrandsEagle ManualsAutomotiveEG6158K
11121314151617181920
- 16
24. Adjust the toe-in of the front end Y
25. Clean the body and seat Y
After above maintenance, drive the vehicle to check if the vehicle works properly.
8. Storage
Please follow the steps as below when the vehicle is stored.
1. Check the liquid level inside the battery; recharge it fully before storing the vehicle.
▼
▼
▼
W
W
W
a
a
a
r
r
r
n
n
n
i
i
i
n
n
n
g
g
g
:
:
:
Please charge the battery once a month if your vehicle will be stored more than one month.
2. Turn the power key to OFF position, remove the key, and store the key in a safe position.
3. Engage the Handbrake.
4. Check the tire pressure to make sure its pressure is set to recommended pressure.
5. Clean the exterior of the vehicle and apply the rust inhibitor.
6. Cover the vehicle with a breathable cover and store it in a dry, safe and well-ventilated place.
7. If the vehicle is planned to store for a longer time, then please check the liquid level inside the battery once a
month, recharge the battery
9. Trouble Shooting
There is no settled mode to diagnose and eliminate the malfunction of electric vehicles. During maintaining
and checking, we suggest you first listen, then look and feel. Below is the diagnoses and maintenance of some
common malfunctions.
1) The vehicle doesn’t move. Turn on power key, step on the accelerator pedal, the vehicle doesn’t
move.
Malfunction Possible reason Troubleshooting
1.Connector(s) in Circuit is loose or open Tighten or connect
2.Fuse of controller or main circuit is open Change fuse
3.Battery cable(s) is loose or disconnected Tighten or change
4.Power key is broken Change
5.Volatmeter is broken Change
Turn on power key,
Voltameter has no signal
6.Battery terminals connect improperly Adjust
1.Improper operating procedure Operate properly
2.Controller Failure Check or Change
3.Solenoid Failure Check, repair, change
4.Accelerator Failure Repair or Change
5.Motor Failure Repair or change
6.Parking brake doesn’t loosen Loosen parking brake
Turn on power key,
Voltameter has signal.
7.Over-heat protection Check, eliminate