User`s manual

- 5
Gearshift —— There is totally 5 positions. Forward shift includes 1, 2, 3 and 4.
Reverse shift is R. It is recommended to use 1 for climbing, use 2, 3 and 4 for
flat road.
5. Operational Process
5.1 Start the vehicle
1) Switch on the power key;
2) Step the clutch pedal to the bottom, select 1
st
position if go forward and R position if go backward. If go
forward, after start the vehicle, change to right shift and make sure to use right speed when driving.
Selection standard is to make sure that the working current of motor stays as small as possible as long as
this current is enough for driving.
3) Release the parking handbrake lever.
4) Release the clutch pedal slowly.
5) Step down the acceleration pedal smoothly; in this case, the vehicle starts running.
▼
▼
▼
W
W
W
a
a
a
r
r
r
n
n
n
i
i
i
n
n
n
g
g
g
:
:
:
If you step the acceleration pedal before switching on the power key, the vehicle will not run. In this case, you
should release the acceleration pedal first, and step it again, thus the vehicle will start running.
5.2 Stop the Vehicle
1) Step the service brake pedal to decelerate the vehicle until it stops completely and shift the gear to Null
position;
2) Engage the handbrake lever to park the vehicle;
3) Release the service brake;
4) Switch off all lights;
5) Switch off the power key and take out the key.
5.3 Charge the batteries
C
C
C
a
a
a
u
u
u
t
t
t
i
i
i
o
o
o
n
n
n
!
!
!
1) We have two different kinds of charger for you to choose, one is exterior charger and the other is build-in
(on-body) charger. Before you use the charger, please read the charger operation manual which attached with
the charger.
2) Explosive hydrogen gas is produced while battery is charged. Only charge the battery in well-ventilated
areas.
3) Before using the charger, please check if the battery charger you are getting to use is correctly rated as per
your local AC electricity network.
5) Do not disconnect the DC output cord from the battery receptacle when the charger is ON, otherwise an arc
could occur which may cause an explosion.
7) It is prohibited to open the housing of the charger.
8) Only qualified electrician is allowed to open the housing of the charger.
9) The charger should be stored in safe and dry room with good ventilation.