User`s manual

- 6
10) The charger should be packed properly if not used for long time.
Below is the charging procedure:
·Turn Off The Power Of The Whole Vehicle
1) When it’s non-onboard charger, one set of batteries, the process is as follows:
a) Connect charger to DC receptacle on the vehicle;
b) Connect the charger to AC power;
c) Turn on the charger
d) Turn off the charger when the batteries are fully charged, disconnect the charger from AC power first, then
disconnect the charger with AC receptacle;
2) When it’s non-onboard charger, two sets of batteries, the process is as follows:
a) Disconnect the two DC receptacles under the driver’s seat, refer to left picture;
b) Connect the chargers to the DC receptacles, one charger to one receptacles;
c) Connect the chargers to AC power;
d) Turn on the chargers;
e) Turn off the chargers when the batteries are fully charged, disconnect the chargers with AC power first,
then disconnect the chargers with DC receptacles;
f) Connect the two DC receptacles under the driver’s seat.
3) When it’s onboard (build-in) charger(s), no matter there is one set or two sets of batteries, the process is as
follows:
a) Connect the charger(s) with AC power;
b) Turn on the charger(s);
c) Turn off the charger(s) when the batteries are fully charged, disconnect the charger(s) with AC power;
6. Rules for Safe Operation
The driver should have a good knowledge of the operation system of the vehicle and its features; meanwhile
follow the rules for safe operation.
▼
▼
▼
W
W
W
a
a
a
r
r
r
n
n
n
i
i
i
n
n
n
g
g
g
:
:
:
l Drive the vehicle off road unless it is allowed.
l The vehicle cannot be over-loaded, otherwise the motor will be damaged, the vehicle will lose control
and its life will be shortened.
l Unqualified persons are prohibited to drive the vehicle.
l Make sure this vehicle runs in its rated climbing ability.
l Don’t overtake other vehicles at crossroad, in blind area or in other dangerous zone.
WHILE OPERATING THE VEHICLE
l Keep your entire body inside the vehicle, keep seated and holding on while the vehicle is moving.
l Do not start the vehicle until all occupants are securely seated.