Operating Instructions and Installation Instructions

adjustable strap. These are "kick-up" mounting brackets. They help

prevent damage if the transducer strikes an object while the boat is

moving. If the transducer does "kick-up" the bracket can easily be

pushed back into place without tools.

Read these instructions carefully before attempting the installation.

Determine which of the installation methods is right for your boat.

Remember, the transducer location and installation is the most

critical part of a sonar installation.

Recommended Tools and Supplies

If you prefer the option of routing the cable through the transom, you

will need a 5/8" drill bit. If you intend to install an additional speed or

temp sensor and route its cable through the same hole in the transom,

you will need a 1" (25.4 mm) drill bit to accommodate all the cables.

NOTE:

The following installation types also call for these recommended

tools and required supplies that you must provide (supplies listed

here are not included):

Single-frequency transom installations

Tools: two adjustable wrenches, drill, #29 (0.136") drill bit, flat-head

screwdriver. Supplies: none.

Dual-frequency transom installations

Tools: two adjustable wrenches, drill, #20 (0.161") drill bit, flat-head

screwdriver. Supplies: four, 1" long, #12 stainless steel slotted wood

screws.

Single-frequency trolling motor installations

Tools: two adjustable wrenches, flat-head screwdriver. Supplies: plastic

cable ties.

Shoot-through hull installations

Tools: these will vary depending on your hull's composition. Consult

your boat dealer or manufacturer. Other tools are a wooden craft stick

or similar tool for stirring and applying epoxy and a paper plate or

piece of cardboard to mix the epoxy on. Supplies: rubbing alcohol, 100