Instruction manual

SAFETY PRECAUTIONS
Please familiarize yourself with the
following information to prevent damage
to your compressor unit and injury to the
operator.
CAUTIONS
The air compressor and motor will get
hot while in operation. Never touch the
discharge tubing, motor or compressor
pump while in operation. The
compressor operates automatically
while the power is connected and turned
on.
Compressed air from the unit may
contain hazardous fumes. Air produced
by this compressor is not suitable for
breathing purposes. Always use a
respirator when spraying paint or
chemicals, or when sandblasting.
Always wear safety glasses or goggles
when using compressed air.
It is not practical or possible to warn you
about all the hazards associated with
operating or maintaining this equipment.
You must use your own good judgment.
AIR RECEIVER
over pressurizing the air receiver could
cause personal injury or material
damage. To protect from over
pressurizing, a factory pre-set safety
valve is installed.
NEVER WELD, DRILL OR CHANGE THE
AIR RECEIVER IN ANY WAY.
Any replacement parts should be
purchased with the same specifications
as the original equipment. Please
contact the authorized dealer for
replacement parts of specifications.
SAFETY VALVE
This valve is factory installed to prevent
over pressurizing of the air of the air
receiver. it is factory set at a specific
limit for your particular model, and
should never be tampered with.
Adjustment by user will automatically
void the warranty.
DO NOT REMOVE, MAKE ADJUSTMENTS
TO, OR SUBSTITUE THIS VALVE!
AUTOMATIC DRAIN
The unit is equipped with an air-
actuated automatic drain, which
automatically discharges air receiver
condensation each time the compressor
starts and stops. Some models may
have different type of drains.
OIL FILTER (OPTIONAL)
This is a coalescing filter, which
removes oil droplets and aerosol mists
from compressed air. They may also be
used as a pre-filter to extend the life of
your membrane dryer.
All filters are equipped with internal float
drains to facilitate the removal of liquid
contaminants.
INSTALLATION
1. Installation
Proper care, maintenance and
lubrication ensures longevity. The
compressor should always be level for
proper lubrication. Use only in a clean,
dry and well ventilated area. The
compressor has heat dissipation fins for
proper cooling. Keep the fins and other
parts that collect dust clean. Do not
place rags or other materials on top of
the compressor, as this obstructs
cooling and can be a fire hazard.
-2 -