Installation Guide
1 . Screw the four cross bolts into the corresponding holes
( the longest one is used for the top mounting hole).
3
3. Make sure the cable through the mounting plate, secure the
mounting plate, then fix the front body with three screws.
In order to make the back body fit better with the door, PLEASE
" Fully insert the protruding ring on the back of the panel into the
door hole.
Install the three screws at the bottom first, and then install the top
one screw."
Left-Hand Door Right-Hand Door
5 . After connecting the cables make sure the thumb knob is
horizontal ( Left- Hand Door) or turnisvertical ( Right- Hand Door)
according to the door opening direction, then hold the back body
onto the mounting plate.
7. Place the batteries, and make sure the direction of the batteries
is correct, and put in the battery cover.
4 . Pass the cable of the front body through the rectangular hole of
the rubber pad and the door panel. Connect it to the wire cable
connector of the back body.
NOTE: The cable must be passed below the deadbolt to ensure
the deadbolt cannot be hindered.
6 . Fix the back body to the mounting plate with 3 screws. You can
put the rubber stopper on the bottom screw hole to make it look
better.
and cable through the door hole.
Left- hand door: rotate left to the end and insert in
Right- hand door: rotate right to the end and insert in
9 . If you want the lock
automatically locked after
close the door, please install
the door switch sensor.
8. Drill the strike box and strike
plate according to the size,
then fix them by two screws.
2 . Hold the front body to the door and make sure the key nail piece
04
If you turned the toggle to R, turn the knob counter
clockwise to the end ( with the " dot indicator" on the
knob oriented upwards)
If you turned the toggle to L, turn the knob clockwise
to the end (with the "dot indicator" on the knob
oriented right)
Note: Before installing back body, please identify right
open or left open of the door. Please follow up the
instruction to setup the right open or left open.
03
Check the door's opening direction: if the door is Left-Hand Door, toggle the button to the Left, and if the door is Right-Hand Door, toggle it to the
Right. Make sure the thumb knob turns towards according to your opening direction.
up
70 mm 6 0m m
2- 3/ 4 2-3/ 8
NOTE:
The deadbolt has TWO
length options ：70 or
60 mm. Please adjust it
by yourself (if needed).
3.Twist in the opposite
direction to secure the
other one
.
1.Twist manually to
disengage the buckle
.
2.Adjust the length
as required.
70 60
up
70 60
2
up
70mm
60mm
6 0 mm
up
70 60
R L
1