Full Product Manual

ManualsBrandsEAGO ManualsBath66 in. Acrylic Flatbottom Air Bath Bathtub in White

AM 213 Installation Introduction

E-mail:sales@eago.com.cn Http://www.eago.com.cn

National Service Hotline：+86 800-8301359

EAGO Sanitary Ware Co.,Ltd.

Factory Add:Shiling Development Zone,Xiaotang Town,Nanhai District,Foshan City,Guangdong,China

Summary of content (7 pages)

PAGE 1
EAGO Sanitary Ware Co.,Ltd. Factory Add:Shiling Development Zone,Xiaotang Town,Nanhai District,Foshan City,Guangdong,China E-mail:sales@eago.com.cn Http://www.eago.com.
PAGE 2
Safety Information Maintenance Instruction 1 Please read carefully and follows all instruction when operating. 1. The cleaning of the acrylic surface： 2 The sponge and water could be used for the daily maintenance. If there are scratches appear in the surface, please use the 1500 waterproof abrasive paper to polish the surface. Then use toothpaste to polish again. Also some dirt cleaning machine could be used.
PAGE 3
AM 213 Components Structure AM 213 Components Structure 01 1.Bathtub 2. Air pipe 8. A P700 Air pump 9.Stainless steel bracket 3.PR0105-B401 Control panel 4.3623A-100 Drain 5.PC board clip 6.PR0105-B401 PC board 7.90 degree elbow 10.
PAGE 4
AM 213Water and Wire Instruction Diagram Installation Step The product use the standard accessories. Please refer to the production tech parameter and follow the installation step as below: 770 1.Confirm the product install position→2. Adjust the product to horizontal → 3.Connect the water inlet and drain pipe→4.Connect the power→ 5.Check and confirm→6. Reposition→7.Water testing 1.
PAGE 5
Wire Connection Diagram for Whirlpool Bathtub Control Panel Usage Instruction (AM213) PC control panel Bubble function instruction: Bottom Light Bubble Shower Bubble Shower Speed Power ON/OFF Button 2. The power of the bubble: weak, middle and strong. 3.
PAGE 6
Maintenance Card Model No. Model No. Manufacturing Code Maintenance Card Purchasing Date Tel Add Maintenance Record Maintenance Maintenance Date Item Maintenance Unit Maintence person signature Manufacturing Code Customer Name Tel. Maintenance item: 1. Every purchase of the series products, get 1 year guarantee by the maintenance service card and purchasing receipt since the purchasing date. The following cases are not covered by the warranty. Add. A.
PAGE 7
Troubleshooting Malfunctions Causes 1. The steel stand at bottom of bathtub is not balance. The bathtub 2. The fasten screws for shaking and motor and shockproof 1. Adjust the leg to make the steel stand even. 2. 4 Pieces of screw and 4 shockproof rubbers shall be provided of the motor. Fasten the nuts. ‘make noise. rubber is incomplete close. 3. Contact with your dealer or the 3. Problem of motor. manufacturer. 1. The suction net partly 1. Take off the suction net with screwdriver.