Specification

Installation Manual of Tank FittingInstallation Manual of Tank Fitting
General DrawingGeneral Drawing
Please give the manual to the end user. Please
read the manual thoroughly before using it.
Connect Water supply Tube
1 The Installation of Fill Valve
The Installation ManualThe Installation Manual
3) To
install into tank, remove
locknut and slide Fill Valve
into the hole in tank. Next,
position Fill valve to desired
position and tighten the
locknut.
(Torque <2.2 LB-FT)
installing Fill Valve:
(DO NOT OVER TIGHTEN)
1)
To adjust height, push the
up, turn the
upper shank clockwise to
unlock teeth from lower
shank. Next, adjust the
height by pulling up or down
on upper shank to set at
desired height.
Adjust Height of Fill
Valve:
Tamper proof
2) After adjusting height of
Fill valve, rotate the upper
shank counter clockwiseto
lock into lower shank. Next,
push down
On to secure it.Tamper proof
Upper Shank
Lower Shank
Tamper proof
2.The installation of Outlet Vlave
Rotate the flush valve body separate
the body from base as shown in the
Fig.
Install the flush valve base into the
outlet to make the "U" clasp can
clip on the tank properly. Rotate
the base to choose proper
angleand lock the screw.
Install the flush valve body on
the base again, rotate it to a
proper position and lock.
body
base
base
screw
body
base
Attention: If the product is different from the drawing , Please take the object as right.
Cut the adjustment rod to a
proper length, put the push
button into the hole.
Tighten the nut.
Adjust the direction of the
push button. Be sure the full
flush Button toward the full flush
Touch piece.
Full flush
Partial flush
3.Push button installation
WARNING: Do not use in-tank type bowl cleaners in your toilet. In-tank cleaners containing
chlorine or bleach can seriously damage the internal components of your toilet causing leaks
and flooding. We will not be responsible for any damage that is caused by the use of in-tank
cleaners in your toilet.