Tank Flushing Manual

1
562471 08--A1
2
3
1
2
2
3
1
3
Installation Manual of Tank TrimInstallation Manual of Tank Trim
Please show the manual to final customer.
General DrawingGeneral Drawing
Do not use an in-tank type bowl cleaner in your toilet. In-tank cleaners containing chlorine(calcium hypochlorite) can seriously damage fittings in the tank. We shall not be responsible for any tank fitting damage caused by the use of cleaners containing chlorine(calcium hypochlorite). We will not be liable for damages due to improper handling or installation, abuse, or alteration of the product. We disclaims any responsibility for incidental or consequential damages. WARNING:
Connect Water supply Tube
1. Installation of fill valve
Installation
Note: when the water pressure is lower than 0.4Mpa, turning on the nut and bringing out the restrictor.
Rotating the adjustment rod can make the float move up and down to preadjust the water level height.
Rotating the adjustment rod can make the float move up and down to preadjust the water level height.
restrictor
nut
Screw the flush valve tight, and make sure the fixture block and seal washer attach on the tank wall. Put the flapper on the flush valve .
Adjust the angle of the flush valve, make sure the flapper is easy to open, and the chain is not blocked.
Screw the flush valve tight, and make sure the fixture block and seal washer attach on the tank wall. Put the flapper on the flush valve .
2.The installation of flush valve
3.Installation of push button
Loose the nut clockwise take away the nut and the washer from the rod.
Washer
Nut
Connect Rod
Install the rod into the tank handle hole.
Enter the nut on the handle and tighten.
Attention: If the product is different from the drawing , Please take the object as right.