Datasheet

Bi-colour LED,T1 Bi-Pin

Illumination colour Lumi. Intensity Dom. Wavelength Forward voltage Part No.

Wiring

diagram

Red / Green 1000/1800 mcd 628 / 525 nm 1.9 / 3.5 VDC @ 20 mA 10-2603.320AL 352

Green / Yellow 1100/900 mcd 588 / 525 nm 2.0 / 3.2 VDC @ 20 mA 10-2603.320CL 352

Additional information

• The customer has to decide what series resistor shall be used to the LED

• Luminosity and wave length variations caused by LED manufacturing processes may cause slight diffe-

rences regarding the illumination. The customer has to decide what resistor shall be used to the LED

Wiring diagrams

Wiring diagram 352

Switching element with illumination and plug-in terminal

IP Protection Illumination colour Operating voltage Operation current Terminal Part No.

Wiring

diagram

IP40 Red 12 V DC ±10 % 10 mA Plug-interminal 84-8511.2320 354

Orange 12 V DC ±10 % 10 mA Plug-interminal 84-8511.3320 354

Yellow 12 V DC ±10 % 10 mA Plug-interminal 84-8511.4320 354

Green 12 V DC ±10 % 10 mA Plug-interminal 84-8511.5320 354

Blue 12 V DC ±10 % 10 mA Plug-interminal 84-8511.6320 354

White 12 V DC ±10 % 10 mA Plug-interminal 84-8511.9320 354

Red 24 V DC ±10 % 10 mA Plug-interminal 84-8511.2620 354

Orange 24 V DC ±10 % 10 mA Plug-interminal 84-8511.3620 354

Yellow 24 V DC ±10 % 10 mA Plug-interminal 84-8511.4620 354

Green 24 V DC ±10 % 10 mA Plug-interminal 84-8511.5620 354

Blue 24 V DC ±10 % 10 mA Plug-interminal 84-8511.6620 354

White 24 V DC ±10 % 10 mA Plug-interminal 84-8511.9620 354

Contacts: NO = Normally open

Additional information

• LED and built-in resistor included

• Standard version: Cable length 300 mm with insulated ferrule, plug-in terminal 2.8 mm x 0.5 mm

• Other options on request: Customisation of cable and connectors, rear side fully sealed (IP 67)

• Protection degree (rear side): IP 40, upgrade to IP 67 with plug Part No. 84-900 possible. With applicati-

ons where strong vibrations occure, the plugs may become loose

• Luminosity and wave length variations caused by LED manufacturing processes may cause slight diffe-

rences regarding the illumination. The customer has to decide what resistor shall be used to the LED

Components

X2+

X1–

01/2019 § eao.com

919