User's Guide

©Copywrite 2021 EAR Micro
Charging
Opening/Closing the Doors
Your T10 Charger has “Gull-Wing” doors that hinge at the top to keep your precious buds securely in
place. To Open the doors simply lift the door gently from the bottom and the spring will do the rest to
fully open the charger door and reveal your brand new T10s. To Close the door one finger will do. Just
nudge it back closed until the magnetic closure snaps the door into the closed position.
Removing/Replacing the Buds
Once the doors are opened you can grasp the sides of the buds to remove them from the case. Be
careful not to touch the Klipsch logo face as it is a touch interface and inadvertently answer a phone call,
start playing music or some other function.
When putting the buds back into the charger, we recommend placing the ear tip in first and then
rotating the bud to fully seat it in the charger.
After closing the both doors you will see the red LED through the window on the charger door turn off
after a few seconds. The buds will charge and the charger will put them to “Sleep” when fully charged.
Charger User Interface
Open Door
Upon Opening either door the LEDs on the charger will sequence from the open door across the 5 LEDs
and cycle back off to indicate the door has been opened. The LEDs will then sequence from the open
door across the charger to indicate the battery level in the bud with the open door. A single LED
illuminated closest to the open door indicates the bud’s battery is between 10% and 30% charged. Two
LEDs means between 30% and 50%, three LEDs is between 50% and 70%, four LEDs is between 70% and
90%, five LEDs is greater than 90%. No LEDs lit means it needs to be charged.
Button Gestures
The button on the charger gives you several functions on the charger and buds while the buds are in the
charger. A quick press and release of the button is what we refer to as a Touch. A Hold is where you
press the button and hold it down. When holding the button down on the charger, the LEDs will Count
the seconds for you as they illuminate from left to right. Once the charger has reached 5 seconds it will
start back at the left LED position. The count will continue until you release the button or hold for 30
seconds.