Data Sheet

Module：EWN-8258FAT1CC
Waiting for your suggestion at anytime.
-
19 -
E-mail：[e-mail]
OEM integration instructions:
This device is intended only for OEM integrators under the following conditions:
The transmitter module may not be co-located with any other transmitter or antenna. The
module shall be only used with the external antenna(s) that has been originally tested and
certified with this module.
As long as the conditions above are met, further transmitter test will not be required.
However, the OEM integrator is still responsible for testing their end-product for any additional
compliance requirements required with this module installed (for example, digital device
emissions, PC peripheral requirements, etc.).
Validity of using the module certification:
In the event that these conditions cannot be met (for example certain laptop configurations
or co-location with another transmitter), then the FCC/IC authorization for this module in
combination with the host equipment is no longer considered valid and the FCC ID/IC of the
module cannot be used on the final product. In these circumstances, the OEM integrator will be
responsible for re-evaluating the end product (including the transmitter) and obtaining a
separate FCC/IC authorization.
End product labeling:
The final end product must be labeled in a visible area with the following: “Contains
Transmitter Module FCC ID: 2AMM6-8258FAT1CC. Contains IC: 26313-8258FAT1CC.”
Information that must be placed in the end user manual:
The OEM integrator has to be aware not to provide information to the end user regarding
how to install or remove this RF module in the user's manual of the end product which integrates
this module. The end user manual shall include all required regulatory information/warning as
show in this manual.