Specifications
Table Of Contents
Integration instructions for host product manufacturers according to KDB 996369 D03
OEM Manual v01
2.2
List of applicable FCC rules
CFR 47 FCC PART 15 SUBPART C has been investigated. It is applicable to the modular transmitter
2.3
Specific operational use conditions
This module is stand-alone modular. If the end product will involve the Multiple simultaneously transmitting
condition or different operational conditions for a stand-alone modular transmitter in a host, host manufacturer have
to consult with module manufacturer for the installation method in end system.
2.4
Limited module procedures
Not applicable
2.5
Trace antenna designs
Not applicable
2.6
RF exposure considerations
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
2.7
Antennas
This radio transmitter FCC ID:2AMM6-8822CSS3AH has been approved by Federal Communications
Commission to operate with the
antenna types listed below, with the maximum permissible gain indicated. Antenna types not included in this list that
have a gain greater than the maximum gain indicated for any type listed are strictly prohibited for use with this
device.
Antenna No.
Model No.
of antenna:
Type of antenna:
Gain of the antenna
(Max.)
Frequency
range:
Bluetooth / PCB Antenna 2.0dBi for 2400-2500MHz;
2.4GWiFi / PCB Antenna 2.0dBi for 2400-2500MHz for Ant1&2
5GWIFI / PCB Antenna 2.0dBi for
5000-5900MHz for Ant1&2
2.8
Label and compliance
information
The final end product must be labeled in a visible area with the following" Contains
FCC ID:2AMM6-8822CSS3AH"
.
2.9
Information on test modes and additional testing
requirements
Host manufacturer is strongly recommended to confirm
compliance with FCC requirements for the transmitter when
the module is installed in the host.
2.10
Additional testing, Part 15 Subpart B
disclaimer
Host manufacturer is responsible for compliance of the host system with module installed with all other applicable
requirements for the system such as Part 15 B.










