EarFun Free Pro ANC Wireless Earbuds
01
1 What’s in the Box EarFun Free Pro Ear Hooks（S, M, L） 2 Charging Case Ear Tips (XS, S, M, L) USB-C Cable User Manual Product Diagram 2 1 4 1 3 5 7 6 8 01 1 Touch multifunction control 2 LED indicator 3 Microphone 4 Charging contactor 5 USB-C charging port 6 Charging case 7 Charging dock 8 Charging case indicator
3 Charging 1.Open or close the charging case to activate the LED battery indicator. 2.Remove the film on the earbuds when taking them out of the charging case for the first time. 3.Fully charge both the earbuds and the charging case before the first-time use. 4.The charging case must be close that earbuds can start charging. 5. Fully dry off the earbuds and the USB port before charging.
4 Specifications Bluetooth frequency 2.402GHz-2.48GHz Bluetooth profile A2DP, AVRCP, HFP Maximum working range 15m(without obstacle) Battery capacity 50mAh x 2(earbuds); 400mAh(charging case) Charging time 1hour(for earbuds); 2 hours(for charging case via USB-C); 3.5 hours(for charging case via wireless charger) Playtime Up to 7 hours, Totally 32 hours with the charging case; (varies by volume level and audio content) Input DC 5V / 1A Dimentions 66.70mm x 25.00mm x 30.
Pairing Your Earbuds 1. First time pairing with device Step 1: Open the charging case, earbuds will automatically power on and enter into pairing mode. Step 2: Activate Bluetooth on your Bluetooth-enabled device and search for other Bluetooth devices. Step 3: Select “EarFun Free Pro” from the list of Bluetooth devices shown (if a password is needed, type ‘0000’). EarFun Free Pro Notes: ● The earbuds will automatically connect with the device they were last paired with when the case is open.
Option B Step 1. Make sure earbuds are power on, and then touch and hold the both earbuds touch button at the same time for at least 3s until flash the blue, the earbuds will into pairing mode. Step 2. Search on the new device and connect. R L EarFun Free Pro 3S 7 Functions Power on/off Open the charging case, the earbuds will automatically power on. Place the earbuds back into the charging case. Close the case and the earbuds will automatically power off.
Volume up X1 Tap once (R) X1 Tap once (L) L/R Volume down L Hands free conversation Answer/End a call X2 Tap twice (L/R) 2S Tap and hold for 2s (L/R) X3 Tap triple (L/R) 2S Tap and hold for 2 seconds (R) L/R Reject a call L/R Answer and transfer two calls L/R Activate the voice assistant Voice assistant R 06
Noise cancelling control Noise cancelling ambient sound normal X3 Tap triple (L) 2S Tap and hold for 2 seconds (R) L Noise cancelling control Low Latency ON/OFF R 8 Reset and Reconnecting If you fail to build connection between two earbuds, or between earbuds and Bluetooth device, please try the following steps: 1. Place both earbuds into the charging case. 2.
9 Troubleshooting Q: Can I use both earphones separately? A: Yes, each earbud could be used independently. Q: The earphones are turning on, but it doesn’t connect to my device? A: To connect the earbuds to your device, please check if the Bluetooth of the device is on at first, then select ’EarFun Free Pro’ on the Bluetooth list to get paired. If the earbuds still can’t connect to your device, please try to reset it, or contact our customer support.
FCC Statement Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
CAUTION Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. the battery shall not be exposed to excessive heat such as sunshine, fire or the like The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Earfun Technology(HK) Limited is under license. Other trademarks and trade names are those of their respective owners.
