Installation Guide

8. ASSEMBLY AND ADJUSTMENT

Prior to attaching or swapping nozzle accessories always unplug the tool

and allow to cool completely.

The air temperature can be adjusted to suit a wide range of applications. The table below

suggests different applications.

Applications

 Drying paint, varnish color shade samples, filler, adhesives, construction joints and

stucco forms

 Drying wet timber prior to filling

 Removing stickers

 Joining adhesives-Large-surface gluing with contact adhesives, activation of pressure-

sensitive adhesives, acceleration of bonding processes, releasing of bonding points as

well as releasing or bonding of edge band or veneer

 Waxing and de-waxing

 Shrinking PVC wrapping and insulation tubes

 Thawing icy stairs and steps, door locks, car boot lids, car doors or water pipes

 Welding of thermoplastic polymer, flooring materials of PVC and linoleum, PVC-coated

fabric, tarpaulins and foils

 Bending plastic pipes and sheets

 Soldering plumbing joints, tin, special silver solder, SMD elements, cable lugs

 Loosening rusted or tightly-fastened nuts and bolts

 Removing old and even thick coatings of oil-paint, lacquer, varnish and synthetic plaster

 Softening paint caulking and putty

 Lighting charcoal

If you are not sure about the correct setting, start with a low temperature

setting and gradually increase the temperature until you achieve optimum

results.