Use and Care Manual

8.1 USING THE CORRECT ACCESSORY (where applicable)

Icon Description Purpose

Glass protection nozzle

accessory

Deflects the heat away from

glass or other fragile areas.

Ideal for window sills, ledges,

frames and base boards.

Hook nozzle accessory Disperses the heat flow evenly

around the whole work surface.

Ideal for thawing frozen pipes,

soldering pipe work, bending

.plastics or heat-shrinking electrical

.insulating tubing.

Concentrator nozzle

accessory

Directs a concentrated heat flow to

the work surface. Ideal for removing

paint in awkward corners, crevices,

mouldings or beading.

Deflector nozzle

accessory

Directs a long, narrow heat pattern

to the work surface. Ideal for

removing paint or varnish from

large, flat surfaces such as base

boards, doors, stairs, etc.

It should be used in conjunction

with a flat scraper. Vinyl tiles can be

removed by softening the tile and

adhesive.

Scraper Stripping paint, varnish and

removing vinyl tiles.

Detailed scraper Stripping paint and varnish from

window sills.

PAGE 1
8.1 USING THE CORRECT ACCESSORY (where applicable) Icon Description Glass protection nozzle accessory Hook nozzle accessory Purpose Deflects the heat away from glass or other fragile areas. Ideal for window sills, ledges, frames and base boards. Disperses the heat flow evenly around the whole work surface. Ideal for thawing frozen pipes, soldering pipe work, bending .plastics or heat-shrinking electrical .insulating tubing.
PAGE 2
Touching a hot nozzle can lead to serious burns. Before attaching or replacing a nozzle allow the unit to cool down completely by turning it off. Dropped nozzles can set objects on fire. Nozzles must be firmly fitted and secure on the unit. A hot nozzle can set a surface on fire. Place hot nozzles down only on fire-proof surfaces. An incorrect or defective nozzle can lead to heat accumulation and damage the unit. Use only original nozzles as shown in the table. 9.
PAGE 3
9.4 STATIONARY USE This tool can also be used in stationary mode. Place the tool onto the work bench with the gun nozzle ① facing upwards. Secure the power cord to prevent pulling the tool off the workbench. Switch the tool on using the control switch ③ and set to position 2. 9.5 COOLING DOWN The nozzle and accessory become very hot during use. Let these cool down before attempting to move or store the tool.