Replacement Part List

SAFETY OPERATING INSTRUCTIONS
3
MAINS
SWITCH
SHOWN IN
OFF POSI-
TION
WARNING! FIRE AND EXPLOSION HAZARD.
● CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK
OR INJURY, DO NOT EXPOSE TO RAIN; STORE INDOORS.
● The materials used with this spray gun (paint, thinners etc) may
contain hazardous, harmful, explosive or corrosive materials. ALWAYS
COMPLY WITH THE SAFETY INSTRUCTIONS ISSUED WITH THIS
PRODUCT AND THE MATERIAL BEING USED.
● The spray gun must be used only with paints and solvents that have a
suitable flash point for spraying. If in doubt, consult the paint or solvent
manufacturer's data.
● Always ensure there is adequate ventilation when spraying.
● NEVER spray near an open flame, including an appliance pilot flame.
● NEVER smoke when spraying.
● Always disconnect the unit from the electrical outlet when cleaning the
spray applicator.
● Always ensure the spray area is safe and free from all debris that may
present a fire or fall hazard.
● NEVER, under any circumstances, point the spray gun at another
person or animal. In the event of an injury, seek immediate medical
attention.
● NEVER allow children or unauthorized users to operate or play with
the spray equipment.
● Always read the paint manufacturer's thinning instructions before use.
● Always wear the correct protective face mask when spraying. We also
recommend wearing gloves, goggles and overalls.
● You must clean the spray gun thoroughly after each use.
● Use only genuine manufacturer replacement parts.
● Use the spray equipment only as detailed in these instructions.
● Do not use the air hose or power cord to move the Spray Station unit.
● Check the hoses, hose connectors and power cord frequently. Any
worn or damaged parts should be replaced immediately.
● This spray station is recommended for household use only.
● This spray station is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person
responsible for their safety.
IMPORTANT ELECTRICAL INFORMATION
EXTENSION CORDS
Your HVLP spray station is supplied with a power cord that is 6 feet long. Make sure your power cord is in good condition. When using an extension
cord, be sure to use one heavy enough to carry the current your product will utilize. For lengths up to 50 feet, No 18 AWG extension cords should be
used.
DOUBLE INSULATED APPLIANCE
This spray station is a double insulated appliance and, as such, does not require three-way grounding. This product is
equipped with a polarized alternating current line plug (a plug having one blade wider than the other) and does not
require a grounding adapter. This plug will fit into the power outlet only one way.If you are unable to insert the plug fully
into the outlet, try reversing the plug. If the plug should still fail to fit, contact a qualified electrician for further details. Do
not defeat the safety purpose of the polarized plug.
Your spray station can be used with a wide variety of paints, stains and coatings such as latex, deck and fence stain, sealers, varnishes, wood
preservatives, enamels, oil and water-based paints and automotive paints.
However, some materials cannot be sprayed so please check the recommendation of the manufacturer before buying the paint. If a material refers to
brush application only then it usually cannot be sprayed.
THIS UNIT CANNOT BE USED FOR TEXTURED PAINTS. USE OF THESE MATERIALS WILL CAUSE PREMATURE WEAR, WHICH WILL VOID
YOUR WARRANTY. TO OBTAIN THE BEST RESULTS FROM YOUR SPRAY STATION, PLEASE READ THE INSTRUCTIONS CAREFULLY
BEFORE USE.
IMPORTANT: SELECTING PAINT
PARTS LIST
No.Description Part Code
1. Needle and Fluid Tip Tool V0018
2. Air Cap Ring V0001
3. Air Cap V0002
4. Spray Pattern Adjustor V0003
5. Fluid Tip 2.0mm V0004
6. Fluid Tip O-Ring V0005
7. Fluid Needle 2.0mm V0006
No.Description Part Code
8. Lip Seal - Fluid Needle V0007
9. Paint Flow Adjuster V0011
10. Paint Container Seal L0682
11. Pick-up Tube V0012
12. Paint Container V0014
13. Hose L0896
14. Filter L0290
Fig.1
V0222 HV3500:Manual 12/1/10 15:26 Page 3