Installation Guide

OPERATION

• Prepare the spray gun for operation (refer to Spray Gun Instruction Manual supplied separately).

• Plug cordset into turbine unit.

• Attach the nut at the end of the air hose to the air outlet on the turbine ensuring it is screwed on

fully. The connection will be rigid when fitted correctly.

• Join the quick connect hose attachment to the air inlet on the spray gun. Tip: If connection is

tight, loosen the quick connect fitting on the hose by unscrewing a little before connecting to the

gun, then retighten.

• Unpack turbine and check all parts are present (see parts list) and undamaged.

• Prepare surfaces to be sprayed ensuring they are clean, dry and smooth.

• Ensure there is adequate ventilation.

• Mask off all areas not intended for spraying.

PREPARATION

PAGE 1
PREPARATION • Unpack turbine and check all parts are present (see parts list) and undamaged. • Prepare surfaces to be sprayed ensuring they are clean, dry and smooth. • Ensure there is adequate ventilation. • Mask off all areas not intended for spraying. OPERATION • Prepare the spray gun for operation (refer to Spray Gun Instruction Manual supplied separately). • Plug cordset into turbine unit. • Attach the nut at the end of the air hose to the air outlet on the turbine ensuring it is screwed on fully.
PAGE 2
• Connect cordset to a grounded outlet. • Turn the power on ‘|’ (5). • Familiarize yourself with spraying technique (for detailed instruction on how to operate spray gun refer to Spray Gun Operating Instruction Manual supplied separately) using waste cardboard. • When you are happy with your set-up, commence spraying. NOTE: Check the turbine unit, filters and the gun are clean and dry before operating. NEVER leave the turbine unsupervised while plugged in.