Specification
This powerful spray system applies coatings faster than brushing or rolling whilst maintaining a
smooth and accurate finish.
The SprayPort® series is designed for the professional decorator and finisher. The latest
technology and materials combine to deliver a consistently high performance.
The SprayPort® series is simple to set up using quick-connect fixings.
The spray gun delivers a high volume of air via the fluid tip for a precise finish.
The powerful steel turbine incorporates open cell air filters for a continuous and clean air flow.
Air is fed to the gun through the lightweight HyperFlex hose made from Thermo-Vulcanised
Polymer.
The HV6000 series sprays a wide range of paint with or without dilution.
To achieve the desired results only use good quality paint or coating. Keep in mind that low
temperatures make paint or coating thicker. Therefore use of the Spray Gun is not recommended
below a minimum temperature of 15°C.
INTRODUCTION
TM
TECHNICAL SPECIFICATION
6002 6003
Turbine 2 stage 3 stage
Motor type Tangenal Tangenal
Voltage 120V 120V
Frequency 60Hz 60Hz
Current 9.6A 10A
Air filters Dual removable filters Dual removable filters
Pressure rang psi 4.5 (0.31 bar) psi 5.5 (0.38 bar)
Air flow 90 CFM (2550 l/min) 90 CFM (2550 l/min)
Air Hose
25 (7.6m) vulcanised
polymer
25 (7.6m) vulcanised
polymer
3