Use and Care Manual

MAINTENANCE

Some simple maintenance is required to ensure your SprayPort® continues to perform effectively:

IMPORTANT: Always unplug from the mains ahead of any maintenance.

• Clean/ replace filters.

- Filters will become soiled during use. To remove see diagram below. Clean filters in warm

soapy water.

Check the condition of filter carefully and replace if necessary.

WARNING! Ensure filter is completely dry before installing.

• Cleaning the hose:

- Keep the outer surface of the turbine unit clean by wiping with a damp cloth. Do not submerge

into or flush through with water or any chemical. Regularly check for cracks, leaks and holes.

Replace if necessary.

• Cleaning the unit:

- Keep the outer surface of the turbine unit clean by wiping with a damp cloth. Do not submerge

into water or any chemical.

• Store the unit indoors. Be careful not to twist or trap the cordset.

• No other user serviceable parts.

IMPORTANT:

It is important to regularly check and clean the filters, hose and turbine, paying particular attention

to the air inlets and vents. Failure to do so risks damage to the motor or premature failure.

Servicing and repairs must be carried out by authorized service centres only – contact Earlex

Head Office for details.

PAGE 1
MAINTENANCE Some simple maintenance is required to ensure your SprayPort® continues to perform effectively: IMPORTANT: Always unplug from the mains ahead of any maintenance. • Clean/ replace filters. - Filters will become soiled during use. To remove see diagram below. Clean filters in warm soapy water. Check the condition of filter carefully and replace if necessary. WARNING! Ensure filter is completely dry before installing.
PAGE 2
TROUBLESHOOTING PROBLEM CAUSE ACTION REQUIRED Little or no spray Air inlet blocked Check the condition of the Air Filter (1) and clean or replace Check air inlets, air vents and air hose for blockages Turbine has no power No power at supply Check the power supply Cable fuse has blown Where applicable check fuse and replace if necessary Circuit Breaker (3) has tripped Reset the Circuit Breaker (3) Incorrect or damaged power cord set used Use correct power cord set.