Autofeed CORDLESS PAINTING SYSTEM PR9 OPERATING INSTRUCTIONS Thank you for purchasing the Earlex PR9 Autofeed Paint Roller. BEFORE USE - PLEASE READ THE SAFETY & OPERATING INSTRUCTIONS.
SAFETY OPERATING INSTRUCTIONS l PLEASE READ BEFORE USE l l l l l l l l l l l Do not operate when paint container is empty. l During breaks in painting never allow the roller to be placed on a surface lower than the paint level in the container as this could cause the paint to siphon out. l Always wear protective clothing and as with all decorating, cover furnishings, carpets etc. ALWAYS CHECK PAINT MANUFACTURERS THINNING INSTRUCTIONS BEFORE PROCEEDING.
OPERATING INSTRUCTIONS PAINT Most water based paints and emulsions are able to be used direct from the can. However check the paint manufacturers instructions regarding thinning first. If the paint requires thinning, dilute with water (usually around 10%) and stir well. Paints will need to be stirred thoroughly before use in the PR9. However check the paint manufacturer’s instructions on stirring first.
TAKING A BREAK If you wish to take a short break, switch to the “off” position and place the roller into the resting tray supplied. Ensure the roller is not lower than the level of the paint in the paint container to avoid siphoning. For breaks of up to 24 hours, slide the switch to the OFF position, place a plastic bag over the roller head, tying around the bag to ensure this is airtight. The roller must be kept above the level of the paint container.
To prevent dried paint from blocking the unit, unclip the filter strainer and outlet valve assembly. Then remove the filter strainer and outlet valve by first rotating them approximately 45 degrees anti-clockwise and then pulling. The filter houses a small ball which is held in position by a plastic bridge. To access the ball remove the bridge by using a pair of long nose pliers, tweezers or similar tool for pulling. After removing the bridge the ball can now be tapped out for cleaning.
EC Declaration of Conformity We declare that the unit: PR9 conform to: 89/336/EEC, EN50082-1 Tim Hopper - Technical Director OPTIONAL ACCESSORIES SS100 - 2300W 4.5 ltr steam wallpaper stripper PRA1 - A 1.4mtr extension pole which is ideal for painting hard to reach areas and ceilings. SS50 - 2000W 4.5 ltr steam wallpaper stripper PRA2 - Spare roller cover.