Installation Guide

11
Measure the vertical
height of your fireplace
at the same distance
from the back wall as
your top crossbar is
from the back wall.
Subtract 2 ¼” from this
measurement. Raise
the riser section of the
grate until the top of the
Top Assembly crossbar
is at this measurement.
Hand tighten the set
screws. The maximum
design height of the top
crossbar is 22”, do not
exceed this height.
With the Allen Wrench supplied, now tighten all set screws (6) ½ turn beyond the hand
tight positions. Lay the supplied Blue Flame Log Lighter Model LLS-1626NG on the log
lighter support bars, under the log support tubes, with the gas mixing chamber facing
the same side of the fireplace as your gas supply. Place the completed assembly in the
fireplace with the back of the grate fully against the back wall of the fireplace. Center
the grate side to side in the fireplace.