Installation Guide

7
The measurement from the back of the
Lower Assembly to the log stop must be
no greater than the measurement from
the back wall of the fireplace to the breast
or smoke shield. Adjust the log stop to
the same dimension measured. Hand
tighten the two log stop set screws.
WARNING
Placing the log stop further forward
than instructed may result in fire,
personal injury, property damage or
loss of life. Improper adjustment may
also allow more wood in your fireplace
than it is designed to accommodate.
Next place the Riser Assembly on top
of the Lower Assembly and slide it
down until the two riser tubes are
resting on the Lower Assembly. Do
not tighten the two Riser set screws
at this time.