Installation Guide

8
Take the measurement you made
earlier from the back wall of the
fireplace to the breast or smoke
shield and subtract 2 ½” from this
measurement. This will be the
position of the top crossbar of the
Top Assembly from the back wall.
Install the Top Assembly and adjust
the top crossbar to this
measurement. Make sure the
measurements are the same on both
sides of the top crossbar. For
fireplaces where the smoke shield or
breast is greater than 12 ½” from the
back wall set the top cross bar at its
maximum design position of 10” from
the back of the grate.
WARNING
Placing the top crossbar further
forward than instructed may result
in fire, personal injury, property
damage or loss of life.
Measure the distance between the
inside of the upper refractory clip and
horizontal crossbar of the Riser
Assembly as shown. Make your
measurement along the bottom of the
angled tube.