Installation Guide

9
With the refractory panel
groove side down on a
flat surface mark the
refractory panel in two
locations from the top of
the refractory panel.
Using a metal straight
edge draw a line across
these marks. Now
measure from the side of
the refractory panel,
along the line you just
made and make a mark
at 11”. Now measure 9”
either side of this mark
and make a mark. Using
your straight edge, draw
a line from these marks
to the top corner of the
refractory panel.
Using a utility knife and
the metal straightedge,
cut along each one of
the lines you just made.
It is easiest to lightly
score along each line
and continue to cut
through the board with
successive strokes of
the utility knife. Your
refractory panel is now
the correct size for your
grate configuration.