User's Manual

GPR4 Concrete Scanner

–

User Manual

000002

000021

Earth Science Systems, LLC

February

2019

Page 9 of 28

1. Open the shipping container (see Figure 2) and disconnect the charging cable from the

tablet.

2. Remove the scanner and the tablet from the shipping case. Remove one of the

batteries from the shipping case and attach it to the scanner.

3. If the long handle will be used, remove the three pieces of the long handle from the

shipping case: the wide handle, the telescoping tube, and the scanner clamp. Mount the

scanner clamp to the scanner, then attach the telescoping tube, and finally attach the

wide handle. Adjust the telescoping tube as desired.

4. The tablet computer can be located in one of four locations during the survey (see

Figure 3): on a stand, on the long handle, on the scanner, or held in-hand. For most

surveys, the use of the stand is recommended.

a. For the stand arrangement, connect the long handle and telescoping tube, and

then insert the tube into the holder in the shipping case. Mount the tablet holder

to the wide handle on the stand and then mount the tablet.

b. For the long handle arrangement, mount the tablet holder to the wide handle and

then mount the tablet.

c. For the scanner arrangement, mount the scanner clamp to the scanner and then

attach the wide handle. Finally, mount the tablet holder to the wide handle and

then mount the tablet.

d. For the in-hand arrangement, attached the hand strap to the tablet.