Instructions / Assembly

Tools Needed.

� Broom or leaf blower

� Mixer with paddle (Larger and more powerful mixers and

paddles are better, especially for larger mixes)

� Trowel

For safety purposes, always follow OSHA recommendations such as

wearing safety glasses, gloves and a dust mask or respirator.

Remove any loose dirt, gravel or asphalt from the hole

with

broom

blower. If there is water in the hole, attempt to remove as much as

possible. Do not apply when there is significant water in the hole or

when the asphalt is extremely wet.

Shake the bottle of the EarthCo liquid modifier and pour it into the

pail or other mixing container.

Pour approximately one quarter of the bag of dry mix into the

container and mix. Slowly add the remaining dry mix into the

container until you achieve the desired viscosity. You may not

need to add all of the dry mix.

Continue to mix 3 to 5 minutes after all the dry mix has been inserted.

(The mix should be able to be troweled without significant effort.)

If using over asphalt, add the bag of powdered pigment and continue to mix. If

using over concrete, do NOT use the pigment. Due to the wide variances in the

colors of asphalt and concrete, the colors won’t necessarily match. Coating with

a seal coat over the entire surface, including the repaired area, later will provide

consistent color.

If after following these steps, you determine that due to either weather conditions

or other circumstances that the mix is still too stiff, you may add small amounts

of water until the mix is the desired consistency. However, adding too much

water can slow the cure and weaken the mix and/or cause cracking. If you find

that you have made the mix too liquid, let the mix stand for a couple of minutes

before applying.

After properly mixing, pour the mix int

o the pothole, spreading the mixture evenly

over the bottom of the hole and fill to the top. If the hole is large and another

batch mix is required to complete filling the hole, fill the bottom of the hole first

and then apply another layer (from the next batch over the first).

MIXING AND INSTALLATION INSTRUCTIONS

FOR

EARTHCO DRIVEWAY REPAIR

Trowel the top of the material to a smooth surface. Although you can use the

mix to fill depths up to seven inches, it is less expensive to use gravel, stone,

or any other stable aggregate as a filler and then apply the mix in the top two

inches, or so.

PAGE 1
MIXING AND INSTALLATION INSTRUCTIONS Continue to mix 3 to 5 minutes after all the dry mix has been inserted. (The mix should be able to be troweled without significant effort.) FOR EARTHCO DRIVEWAY REPAIR Tools Needed. � � � Broom or leaf blower Mixer with paddle (Larger and more powerful mixers and paddles are better, especially for larger mixes) Trowel For safety purposes, always follow OSHA recommendations such as wearing safety glasses, gloves and a dust mask or respirator.
PAGE 2
MEZCLAR E INSTRUCCIONES DE INSTALACION Continúe mezclando para 3 a 5 minutos después de que se ha insertado toda la mezcla seca. (Debe ser capaz de manejarse la mezcla con una llana, sin gran esfuerzo.) PARA EARTHCO DRIVEWAY REPAIR Herramientas Necessarias. � � Escoba o soplader de hojas Mezclador con la pagaya (Mezcladores y palas mas grandes y mas potentes son mejores, especialmente para las mezclas mas grandes.