Specifications

Last Updated 5/7/13
19
6. FOLLOW ME button
Push this button to initiate the “Follow Me” function and the remote controller begins
to detect the actual temperature at its location. The remote controller will send this
signal to the indoor unit every 3 minutes until you press the “Follow Me” button
again. The heat pump mini-split will beep to indicate the “Follow Me” feature has
ended if it does not receive the signal during any 7 minute interval. Please insure
that the signal from the remote controller is not blocked.
7. Reset button
Once the recessed RESET button is pressed, all of the current settings will be
cancelled, and the controller will return to the original settings.
8. ON/OFF button
Operation starts when this button is pressed and stops when the button is
pressed again.
9. FAN SPEED button
Used to select the fan speed in the following four steps, AUTO, LOW,
MEDIUM, and HIGH.
10. TIMER ON button
Press this button to activate the Auto-on time setting. Each press will increase
the time setting in 30 minute increments, up to 10 hours, then at 1 hour
increments up to 24 hours. To cancel the Auto-on time setting, just press the
button until the time setting is 0.0.
11. ECONOMY Button
Select this button before going to bed. It will maintain a comfortable
temperature and save energy. This function is available in COOL, HEAT, or
AUTO modes only.
Note: While the unit is running under Energy-Saving Mode, it would be
cancelled if MODE, FAN SPEED, or ON/OFF is pressed.
12. TIMER OFF Button
Press this button to activate the Auto-off time setting. Each press will increase
the time setting in 30 minute increments, up to 10 hours, then at 1 hour
increments up to 24 hours. To cancel the Auto-off time setting, just press the
button until the time setting is 0.0.
13. LOCK Button
Press this “recessed” button to lock all current settings and the remote will not
accept any operation except that of LOCK. Use the LOCK mode to prevent
settings from being accidently changed. Press the LOCK button again to